Clover Electronics CDR1650 Manuel d'utilisateur Page 167

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 178
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 166
9. Installation of additional HDDs
167
9-2. Installation of an additional HDD
Set the jumper setting to “Cable Select” position on the additional HDD.
Note: Be sure that the jumper setting is correct. If not, the system will not
recognize the additional HDD.
Turn off the power. Unscrew and remove the cover.
Install the additional HDD in the space as shown in Fig.9-1.
Connect the power connector and the flat cable to the HDD.
Reassemble the cover.
Turn on the system and confirm that the system recognizes the additional HDD. If the
system fails to recognize the HDD, check the correct jumper settings and secure cable
connections.
Note: After installing the additional HDD, formatting on the new drive should be
performed. Refer to section 7-3.3. for more details.
Vue de la page 166
1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 177 178

Commentaires sur ces manuels

Pas de commentaire